How to hang a Sonder style piece?

Step 1.) Find a place to hang your piece with studs 16” center to center

Step 2.) Take the outer layer (clear with no pictures) and place against the wall where studs are present and mark where to drill [Use two people for this step, one to hold the acrylic and the other to marl]

Step 3.) Using a 3/16'“ drill bit, pre-drill holes for anchors

Step 4.) Tighten (2) 5/16” nuts to the end of the anchor, using a 1/2” driver bit, drive the anchor into the studs until only 1/2” of thread is exposes. After remove nuts.

Step 5.) Hand tighten standoff barrels and 5/16” studs

Step 6.) Place each layer onto the studs [Use two people for this step, one to hold each consecutive layer and the other to place the layers

Step 7.) Once all layers have been place, tighten end caps by hand till snug with no play.